Skip to main content

How to check printer status from the dashboard

Applies toWeb dashboard· Updated

Short answer

Dashboard → Settings → KOT & Printer Connect shows every printing device at the outlet, whether it is online, the state of each printer, the last print result and any warning. You can also send a test print from there.

Steps

  1. Open the page

    Go to Dashboard → Settings → KOT & Printer Connect. The Printers card at the top lists tablets running the RestroFi app and Connect tills. It refreshes on its own, and there is a refresh button on the card.

  2. Read each device

    Each device shows Online, or 'Last seen' with how long ago. A tablet with 'Prints for the outlet' is the one that prints tickets automatically. A till can also show Paused.

  3. Read each printer

    Each printer shows how it is connected (Wi-Fi, Bluetooth, or Connect for a PC printer), the tickets it takes (Bills, Kitchen KOT, Bar KOT) and its state.

    • Ready: working.
    • Not tested yet: set up but nothing has printed on it so far.
    • Offline, Paper out, Cover open: fix it at the printer.
    • Last print failed: the reason is written below, for example 'Printer off or out of range' or 'Bluetooth is off on the tablet'.
  4. Send a test print

    Press Send test print on a device. For a tablet the page waits for the result and shows 'Printed' or the failure reason. If it says the tablet did not respond, open the RestroFi app on that tablet and try again. A Connect till must be online to receive the test.

  5. Check the paired tills

    Under Paired devices each Connect PC shows its version, 'Update available' when it is behind, and 'job(s) queued offline' when prints are waiting on that PC. 'tickets waiting for a till' means the server is holding tickets that no till has collected yet.

  6. What you can change here

    From this page you can turn the print switches on or off, send test prints, pair a new device and unpair a device. Printer addresses and roles are changed on the device itself, in RestroFi Connect → Printers or in the app under More → Printers.

Still stuck?

If you use RestroFi, sign in and raise a ticket from Dashboard → Support so we can see your outlet. You can also email [email protected].